How to Check & Replace a Blown Capacitor in Your Pressure Pump

If your pressure pump isn’t working properly, the culprit is often a blown capacitor. The good news? It’s a simple fix! Below, we’ll show you how to check if your capacitor is blown and replace it in just 7 steps.

How to Tell if Your Pump’s Capacitor is Blown

Before replacing the capacitor, check for these telltale signs:

Your pump buzzes but doesn’t start – The motor is trying to run, but the capacitor isn’t kicking it into action.

The motor heats up fast (within 10-20 sec) when you hold the reset button – A faulty capacitor can’t regulate the power properly, causing overheating.

The pump runs if you manually spin the fan – If you hold reset and use a screwdriver to turn the motor fan clockwise, and the pump starts but stops when power is cut, the capacitor is likely dead.

If your pump matches any of these signs, it’s time to replace the capacitor! Here’s how:

Step-by-Step Guide to Replacing Your Pump’s Capacitor

Step 1: Disconnect Power

Safety first! Turn off the power at the breaker or unplug the pump completely.

Step 2: Discharge Any Stored Power

Press and hold the reset button on the controller. This drains any remaining charge in the faulty capacitor.

Step 3: Open the Terminal Box

Unscrew and remove the terminal box cover on the motor.

Step 4: Locate & Remove the Capacitor

Find the capacitor—it’s usually a white cylinder with two wires attached. Carefully unplug it. (Tip: Take a photo before removing it for easy reconnection!)

Step 5: Install the New Capacitor

Plug in the new capacitor exactly where the old one was connected. Ensure it's secure.

Step 6: Reassemble & Secure the Cover

Reattach the terminal box cover and tighten the screws.

Step 7: Turn Power On & Test the Pump

Reconnect the power and turn on the pump. If everything was done correctly, it should start up like new! 🎉

Final Tips & Safety Reminders

Always check your pump manual for exact capacitor specs
🛠️ Wear insulated gloves when handling electrical components
If unsure, call a pro!

What If the Pump Still Doesn’t Work?

If replacing the capacitor doesn’t fix the issue, your pump may have a deeper electrical or mechanical problem that requires expert attention.

By following these simple steps, you can save time, money, and hassle while keeping your water system running smoothly.

💧 Got questions? Drop us a line or email!

#DIYRepair #PumpFix #HomeMaintenance #HandyHomeowner #FixItFast

Previous
Previous

Stuck Rain-to-Mains Valve? Here's How to Fix It Yourself (And Save Yourself a Headache)

Next
Next

🚰 Pump Keeps Stopping & Starting? Here’s What’s Really Going On! 🚰